Volume showing in libvol

[maxcrook]

I have a volume that shows up when a q libvol is issued however the tape is not physically in the library.

The tape label has a scratch across it so therefore cannot be checked in.

Would and audit resolve this problem ?

I have tried putting it in the library manually but due to the above error the tape is rejected and put into the hopper.

Ideas ???

 

[ProbablyDown]

An audit will work, however make sure all the drives are empty. Do an audit with checklabel=barcode. If there is a scratch on the label you will probably want to replace the label. Alternatively you can do a checkout libvol remove=no. That should get it out of the libvol listing.