VOIBE - Two network ports

[danthelgman]

Hi,

I notice there are two network connections on the VOIBE cards in our system but we are only uing one for each card. I have looked in the system programming but can only see config options for one network card, are we able to use this second connection or not?

Basically we are still having problems with our IP handsets losing sync with the system, everything possiblt has been done to solve this issue. The LDK-300 firmware has been updated and so has the VOIBE firmware, we have also updated the firmware on all our handsets. We also have a dedicated VLAN for our IP handsets so there are no external traffic issues but still we have a problem and we would like to finally solve it, our system maintainer has explored all possible options and spoken with LG directly.

Thanks all for your help.

Danial

 

[doktor]

The second network adaptor is for testing and production. So you Can only use one network port onthaalcentrum VÓIBE.


///doktor

http://www.kandu.dk/spg153996.aspx

 

[doktor]

Here is more information on switches and connectors

Various switches and connectors functions

Switch / Connector Functions Remark
SW1 VOIBE Reset Switch for CPU (S32500C)
SW2 Watch dog enable switch Default : Off
SW4 Pole1~Pole4 : To be determined
CN1 JTAG(Joint Test Action Group) for debug
CN2 and CN3 VoIUE Board Connection
CN4 Serial Interface(RS-232C) Connection
CN5 Only H/W test purpose
MJ1 Network(RJ-45) Cable Connection LAN #1
MJ2 Reserved LAN #2


LED indications

LED Functions Remark
LD1 ~ LD4 Channel Status LED(ON : Busy, OFF : Idle)
LD5 VOIBE DSP Status LED(ON : Busy, OFF : Idle)
LD6 VOIUE DSP Status LED(ON : Busy, OFF : Idle)
LD7~LD8 Reserved
LD9 Operation
LD10, LD14 Link Status LED(ON : Link OK, OFF : No Link)
LD11, LD15 Full-Duplex Status LED(ON : Half-Duplex, OFF : Full-Duplex)
LD12, LD16 Collision Status LED(ON : Collision, OFF : Normal Operation)
LD13, LD17 Speed Status LED(ON : 100Mbps operation, OFF : 10Mbps)




///doktor

http://www.kandu.dk/spg153996.aspx

 

[doktor]

Additional info:

VOIBE can be installed in the universal slot No. 1-6 of the 1st KSU.
The maximum 1 VOIBE can be installed in one KSU and maximum 2 VOIBEs can be installed in ipLDK-100 system.
VOIBE:
Provides the Ethernet interface for S/W applications and VoIP features with optional VoIP daughters.
The VOIBE has the capacity for maximum 24 channels with one(1) VOIUE, and VOIUE provides twelve(12) VoIP channels.

VOIUE:
This add-on board provides 12 VoIP channels. Mounted on VOIBE up to 1 VOIUE.

CAUTION:
When VMIB2, VoIB, VOIBE and WTIB is used together, it is not allowed to install more than 2 boards in the same KSU because of +5V power consumption.
(Ex: it is available in installing VMIB2 & WTIB, but VMIB2, VoIB, VOIBE and WTIB is not available.)


///doktor

http://www.kandu.dk/spg153996.aspx