Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Virtual Office... Using Mobile dirigent solution..

Status
Not open for further replies.

candymanku

Technical User
Joined
Jan 18, 2002
Messages
26
Location
GB
I have been involved with integrating 3 sites into one and basically stripping out all physical office phone hardware and replacing with a mobile dirigent solution.
Basically the PBX does all the call routing, so someone makes a 5 digit office call form the mobile, the GSM transfers the call to the PBX where the PBX then takes over.
One problem I have seen, the mobile number associated to the 5 digit extension is only tagged for outgong calls, so for example if you li trace st xxxxx you cannot see any call traffic because that 5 digit is virtual and not a port assigned extension. This has caused problems because the outgoing call uses the trunk COR and not the individual extension COR (because of the virtual extension thingy, rendering caller ID manipulation inoperable as well as wanting to send certain extension out over other PSTN's via the Partition route tables.
Question is, all, is there a way I can make the PBX recognise the extensions as being physical (without logging them in) and therefore able to use the extension features?
a good one, I know but I'm clutching at straws now for answers... cheers
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top