Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

using ACLs to classify MAC addresses for bridging on 3640

Status
Not open for further replies.
mbaz

mbaz

MIS
Joined
Oct 9, 2003
Messages
1
Location
US
Can anyone tell me if it is feasible/practical to use an ACL on a 3640 FE port to classify certain MAC addresses and then use this information to selectively bridge these frames across a serial link while routing all other? I see that IRB works similar to this but on a protocol basis. Thanks..

mb
 
Status
Not open for further replies.

Similar threads

CPM86
  • Locked
  • Question Question
Cisco isr 4331 with IOS and sip busy fail over to 2nd sip number on pbx?
Replies
0
Views
580
CPM86
CPM86
jobsp90
  • Locked
  • Question Question
I have a issue in my office hospital network regarding using IPPBX software.
Replies
2
Views
554
DavetheChef
DavetheChef
B
  • Locked
  • Question Question
Cisco IP phone 7841 8851 unable to forward all to external number
Replies
0
Views
419
badwolf1686
B
testman1
  • Locked
  • Question Question
SIP telephone ring on second call
Replies
0
Views
449
testman1
testman1
jarod_paris
  • Locked
  • Question Question
firmware for an AP2800 WiFi terminal
Replies
0
Views
630
jarod_paris
jarod_paris

Part and Inventory Search

Sponsor

Back
Top