usernames and using 'login'

[dozier]

We have our PIX setup so that the enable password is not generally known and you must use your username to login. When I login to the PIX with my username and password, I then have to issue the 'login' command and input my username and password again to obtain my account's privilege level. Is there anyway to set it up to only have to login once?

This is using local usernames.

Thanks.

 

[tonymullen]

don't think so. The initial log in is the telnet password or ssh password depending on how you are accessing it (these are required before you can access it this way). If you use the pdm or the console cable then you should only need to log in the once.

 

[dozier]

I had a feeling that was so..

Thanks.