Use value from subreport to make new page

[Hakana]

Hi

I have a report that presents artikels (details) and groups first by Ordrnr and then by a lower ordernr.
If these artikels (details) have material connected i presents these materials in a subreport.

Now if these connested materials should happen to be another artikel ( detail) i want to print a new set of the main report with subreports.

(This should mean that this artikel (detail) connected is not a material but is a struktur och details with connected materials. These connected details also needs a main report with a subreport presenting that artikels connected material.)


Is this possible?

/Hakana

 

[synapsevampire]

Try posting technical information rather than trying to explain it:

Crystal version
Database
Example data
Expected output

-k

 

[Hakana]

Ok, thanks for suggestion.

Well.

In my main report I have groups and below the second group there is a subreport.

This subreport presents information regarding the details in the main report.

My question is this:
Can I add another subreport (or use the one above) that calls the main report again?
Or in worts case can i make a subreport of my main report and add it, and make some selection. (lot to correct if I change something.)

Hope this was better.

/Hakana

 

[GJParker]

It's still a little unclear what you want to achieve here, as SV sdaid you would be better served posting some example data and the expected outcome.

As far as I can tell you want to have a subreport within a subreport and this can't be done in CR

HTH

Gary Parker
MIS Data Analyst
Manchester, England

 

[Hakana]

Hi and thanks for taking time.

I will try to make it clearer.

[ img

http://goto.glocalnet.net/familjenandersson/images/cr.JPG

]

I want to make the same report again if there is a specific outcome from the first subreport(material).
I have tried to enter the selection into the subreport Ing1930artiklar whith no luck.

If i can get the result from the first subreport and enter that in the other I want to print out the same report as the main but with incoming of only one record at a time.

/Hakana

 

[synapsevampire]

Your preference to ignore requested information and chit-chat about requirements rather than supplying technical information is your biggest problem,andthe language barrier doesn't help.

In generalsubreports shouod be avoided, you might consider that someone here might take a different apporach to meeting requirementsandsupply what you have and what you need.

Look at what I asked for, and how you responded.

-k

 

[lbass]

If I'm following you, you could set up the second subreport to be suppressed if the first subreport result does not meet your criterion. You could set up a shared variable in the first subreport to capture the result, e.g.:

whileprintingrecords;
shared stringvar sub1result := maximum({table.string});

Then place the second subreport in its own section below the first, and go to the section expert of the main report and select the section containing the second subreport->suppress->x+2 and reference the shared variable in order to conditionally suppress the section containing the subreport whenever the variable does not meet your criterion, as in:

whileprintingrecords;
shared stringvar sub1result;
sub1result <> "your criterion"

-LB