upgrading tn2302ap hw03 fw014 3

[lifeisloud]

Hi all,

just trying to upgrade a medpro 2302ap v3 (firmware version 14) to the latest version and need to find the document "TFTP_Firmware_download_procedures.pdf" or does anybody know the prodecures I need to take. as i need to upgrade to v46 before i can take it up to the latest version

I have downloaded the 5 bin files for v46

look forward to hearing from any of you

 

[4merAvaya]

ftp://ftp.avaya.com/incoming/Up1cku9/tsoweb/firmware/V46/readme_tn2302ap_f46.txt

Kevin

 

[lifeisloud]

Thanks for this kevin,

but i have already looked at this readme file. Im looking for the pdf highlighted in this document TFTP_firmware_download_procedures.pdf.

thanks in advance

 

[NX01]

You want this document...it isn't a pdf but doc. So you will need word to open
ftp://ftp.avaya.com/incoming/Up1cku9/tsoweb/firmware/TFTP_Upgrade_Process.doc

Here is Avaya's TFTP program used with the IP phones.

ftp://ftp.avaya.com/incoming/Up1cku9/tsoweb/iptel_avaya_tftp.exe

ftp://ftp.avaya.com/incoming/Up1cku9/tsoweb/iptel.pdf


In the future everything will work...

 

[lifeisloud]

NX01

Thanks very much

 

[jdphone]

Disp node-names ip (note done the ipaddress and name of board)
List ip-interfaces (note down the type, slot, suffex, and node name

For the 799C or better use this command: enable filesystem board clanboard login username password
**Username is whatever you make up; password is whatever you make up too

Download latest firmware for your board from support.avaya.com, put on root of C:\
Open DOS prompt and type ftp ipaddress of clan board
Login using login name and pw you created above
Type binary
Type put c:\tn2302ap_v93_hw93.bin or whatever file you downloaded
Type ls ** to ensure you put the file on the clan staging area
Type quit

Back to ASA: type change firmware download, fill out fields f3 to save
Type status firmware download (P) or big C is good, (A) means something is wrong ** fatfingered filename or something
After about 30 sec if you do a list conf all you will see “no board” in the slot
After about 10 minutes you will see the board reappear with the latest firmware on it.