Upgrading Medpro and VAL firmware 1

[ONsiteengineer]

Hi,

Is Upgrading of Medpro and Val boards has the same procedure with Upgrading CLAN? If not, can you give me the steps in both Medpro and VAL. Thanks a lot.

 

[Mitch672]

no. With the MEDPRO (TN2302AP), you use the CLAN to stage the upgrade.

With a CLAN and the VAL board (and the new "Media Processor, TN2602AP), they are "self downloading", you install the firmware via copying it to each board via FTP, then do a self-download (source = target)

Links to the AVAYA support site for upgrading TN circuit pack firmware have been posted numerous times already.



Mitch

AVAYA Certified Expert

 

[ONsiteengineer]

Thanks Mitch,

So CLAN, VAL, And MEDPRO 2602 have the same procedures in upgrading the firmware?

For 2302, I can use CLAN as source of the firmware for 2303 upgrade? is that right?

Thanks a lot.

 

[Mitch672]

yes.

and,

yes. If you are doing a VAL upgrade, the only special step is to "cd /" before you FTP the file, since when you initially connect via FTP to a VAL board, the default is "/annc"




Mitch

AVAYA Certified Expert

 

[ONsiteengineer]

Thanks mitch.

For VAL: let say my folder for firmware is in VALFirmware folder.

So,it should be:

C:/VALFirmware>ftp <ip address of Val>----right?

Thanks a lot mitch.