I will be upgrading a MICS 0x32 with 5.0 software release to a 7.1 software release. I will be using a 6.0 Upgrade Tool Kit. The system has a PRI. Since the PRI is associated with the old system I.D. will I lose the PRI when I upgrade to 7.1 using the Upgrade Tool Kit?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Upgrading from 5.0 to 7.1 with PRI 1
- Thread starter gtechjoe
- Start date
-
1
- #2
curlycord
Programmer
Only if the system ID should change due to some bad upgrade or error.
If adding hardware as well then do it after the upgrade is completed.
=----(((((((((()----=
curlycord
If adding hardware as well then do it after the upgrade is completed.
=----(((((((((()----=
curlycord
- Thread starter
- #3
Thanks curlycord. The 7.1 Upgrade Tool Kit worked well. The only problem I encountered is that the channels were "Deprovisioned" and the "B" channels would not release until I removed the DTI card and re-inserted. Everything else went well. As usual thanks for your help.
- Status
Similar threads
