Unable to set module conf to files

[Bobcat1402]

Hey there,

We have just installed a new FW-1/VPN-1 Module to our system. The unit communicates with the management server okay, status can be retrieved and licenses installed to the module. However when we try to install a policy onto the unit we get an error with the following reason

Reason: Load on module failed - Unable to set module conf to files.

The unit in question is a Nokia IP400 IPSO 3.5 FCS7 running Checkpoint NG Feature Pack 2

Has anyone experienced this error before or does anybody know how to resolve the issue?

Yours hopefully

Shannon

 

[rstockton]

I spent hours on our Nokia box once after an NG upgrade only to find out that since I did the upgrade using Voyager (and not the command line) I was not told I was out of disk space, yet it still listed the module as installed. Installing via the command line (i.e. newpkg) showed out of disk space issues.

I don't believe I had the error you report, however, I did get bad other things (can't remember what they were).

So...it may sound dumb..but..check for disk space on the Nokia box.

hope this helps is some small way....