Unable to route IPX on 2621XM

[EYES]

HI,

I've got a 2621XM IOS 12.02.8 and am having trouble configuring IPX routing. The router is supposed to support IPX routing from the product specs I've found but the commands for IPX do not appear as options. For example if I'm at the prompt router<config-if># (in ethernet 1) and type ipx ? it comes back unrecognized command. No matter what level I'm at I cannot find an IPX command available. My Cisco router books tell me all it takes to enable ipx routing is just that typing it at an interface, but it always comes back as unrecognized. What am I missing?

 

[mainstreetexpress]

Hi
Can you just post the exact IOS from the show version output of the router

 

[EYES]

Mainstreet,

Thanks, for the response, here it is.

SUBNETRTR>sh ver
Cisco Internetwork Operating System Software
IOS (tm) C2600 Software (C2600-I-M), Version 12.2(8)T5, RELEASE SOFTWARE (fc1)
TAC Support:

http://www.cisco.com/tac

Copyright (c) 1986-2002 by cisco Systems, Inc.
Compiled Fri 21-Jun-02 08:50 by ccai
Image text-base: 0x80008074, data-base: 0x80A2BD40

ROM: System Bootstrap, Version 12.2(7r) [cmong 7r], RELEASE SOFTWARE (fc1)

SUBNETRTR uptime is 2 minutes
System returned to ROM by power-on
System image file is "flash:c2600-i-mz.122-8.T5.bin"

cisco 2621XM (MPC860P) processor (revision 0x100) with 27648K/5120K bytes of memory.
Processor board ID JAD06510N1Q (1465415040)
M860 processor: part number 5, mask 2
Bridging software.
X.25 software, Version 3.0.0.
2 FastEthernet/IEEE 802.3 interface(s)
1 Serial network interface(s)
32K bytes of non-volatile configuration memory.
16384K bytes of processor board System flash (Read/Write)

Configuration register is 0x2102