Unable to Connect to Data Environment and commands

[NickBlake]

I have created a program with Data environments and commands in it on my pc. However when I open and run my program on any other pc on the network, other than my PC which I wrote it on, I lose the connection to my data environment and all the commands associated to it. Does anyone know the reason for this and how I can get around it.

Thanks

 

[vb5prgrmr]

NickBlake, have you read FAQ222-2244 yet?

Did you create an instal for you program or did you just copy the exe? If you just copied the exe you need to use the PDW (Package & Deployment Wizard (under tools)) to create an instal package.

Good Luck

 

[vb5prgrmr]

NickBlake, have you read FAQ222-2244 yet? Did you get your problem fixed?

Good Luck

 

[NickBlake]

Yes I have read the FAQ thanks. I did get my problem fixed I copied my project files over to a different network drive and tried to run it from there but the data environment wasn't picking up the commands. I had to delete the data environment and then clicked on add file to insert it back in to my project. This seems to have worked but I don't know why I needed to do that. Any answers as to why would be much appreciated.

Thanks