Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Tunnel is up but not forwarding traffic to destination address

Status
Not open for further replies.
johnbin

johnbin

ISP
Joined
Jan 30, 2004
Messages
4
Location
US
I have a tunnel configured on a cisco 7206. The tunnel is configured to route specific IPs to a filtering server. The tunnel has been working just fine up until I believe I configured BGP on the destination router. Not sure if this was the cause of the problem though. The tunnel is up and it is partially working. Matched IP traffic is going through the tunnel, but the next hop is the destination routers ethernet interface and not not destination IP address I have configured in the tunnel?????

Please help.
 
Status
Not open for further replies.

Similar threads

CPM86
  • Locked
  • Question Question
Cisco isr 4331 with IOS and sip busy fail over to 2nd sip number on pbx?
Replies
0
Views
544
CPM86
CPM86
B
  • Locked
  • Question Question
Cisco IP phone 7841 8851 unable to forward all to external number
Replies
0
Views
392
badwolf1686
B
quazimotto
  • Locked
  • Question Question
Cisco ASA_5505 VPN to Juniper_SRX210 VPN IS UP_ No Traffic!!!!!!
Replies
0
Views
316
quazimotto
quazimotto
Luzbel
  • Locked
  • Question Question
Connecting HVAC controller to network
Replies
0
Views
566
Luzbel
Luzbel
Skip Rango
  • Locked
  • Question Question
how to backup cisco sg500-52p switch
Replies
1
Views
783
madwok
madwok

Part and Inventory Search

Sponsor

Back
Top