Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations bkrike on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
trunk groups
- Thread starter asnetusa
- Start date
You will have to set up a new set of COR's for that group which point to a different time of day chart. eg 2.
This time of day chart (or partition group) can then be set up in the change partition table to route the caller to a different set og routing tables.
The different routing tables will point to the trunk group you have stated.
The ars analysis table may have to be altered to point to the partition table form if not already and based on the COR you are in will determine which partition group you will use and what route you will go through.
It is a little complex if ARS ana is not pointing to the partition table already.
Good Luck
Netcon1
This time of day chart (or partition group) can then be set up in the change partition table to route the caller to a different set og routing tables.
The different routing tables will point to the trunk group you have stated.
The ars analysis table may have to be altered to point to the partition table form if not already and based on the COR you are in will determine which partition group you will use and what route you will go through.
It is a little complex if ARS ana is not pointing to the partition table already.
Good Luck
Netcon1
I have some users located in another building on their own EPN (connected via DS1-Converter), which may be similar to what you want to do.
To allow them to use the trunking in the EPN they operate out of, and not waste TDM slots back to the PPN, I have them in a different ARS Partition. This allows me to have different buildings (or groups) use different trunking to dial the same number.
Setting up is fairly easy but takes some time.
Does that sound like what you want to do?
To allow them to use the trunking in the EPN they operate out of, and not waste TDM slots back to the PPN, I have them in a different ARS Partition. This allows me to have different buildings (or groups) use different trunking to dial the same number.
Setting up is fairly easy but takes some time.
Does that sound like what you want to do?
- Status