Trouble Debugging (Class does not support automation....

[markphsd]

I'm i'm trying to debug my dll. I Run the DLL, start the application. Some functions run, but I get an error only in debug mode on a Enumeration in the one class. Any ideas?

Mark P.

http://www.cafecartel.com

Providing Low Cost Powerful Point of Sale Solutions.

 

[dglienna]

No crystal ball. Don't use the .dll

-David
2006 & 2007 Microsoft Most Valuable Professional (MVP)
2006 Dell Certified System Professional (CSP)

 

[markphsd]

Probably the silliest reply i've ever seen.

however, the title of this post held the solution, error 430. I found that the classid had changed in that class.. so i reregistered the dll and it worked fine.

Mark P.

http://www.cafecartel.com

Providing Low Cost Powerful Point of Sale Solutions.

 

[strongm]

David's response was because, at first glance, your question essentially reads "My program isn't working. Please help

 

[markphsd]

shoulda taken a second glance... and yah, that was probably the sparsest information i had put up for wanting a response.

Mark P.

http://www.cafecartel.com

Providing Low Cost Powerful Point of Sale Solutions.