Trouble adding RAID drivers during OS installation

[visionthing]

I have a new PE SC430 and a CERC SATA 1.5/6 (adaptec 2610SA) controller card. I have ran the Server Assistant and it has created the Virtual disk. When the OS starts/finishes the installation, it will blue screen with a STOP error. I then ran the installation again, this time using the F6 key to add the drivers. It shows the adaptec driver and I select it and it continues to build. However, it then will stop the build and say "setup cannot copy files "aac.sys" and give me the options of "try again", "skip" or "cancel". I've tried various floppy drives and still only get to this part. I've read that this has happened to others but haven't seen any success to this. Can someone offer any ideas? I've been at this for 2 days and am still searching.
Thanks

 

[visionthing]

It turned out to be the wrong driver and when I got the correct one, it installed fine. Thanks for looking.