token ring to ethernet conversion

[bmoher]

I have about four NT 4.0 servers that I have to convert from Token Ring to Ethernet. Is there a procedure or a document I can read that would help me make sure that the conversion is completed properly and there are no remnants of Token ring settings in the registry.<br>
<br>
I have done this before but am not sure I removed token ring completely. Also, I recieve errors on boot up. &quot;Load Error #: 30&quot; and &quot;Load Error #: 5&quot;.

 

[member 141630]

Token ring is simply a piece hardware (the 'physical').
Ensure you remove the IP address first from the token cards and reboot before removing any cards from an NT/2000 machine otherwise this gives headaches later on....
Then you'll be OK....