TN790 Processor Firmware

[GTD5]

I have a problem with a checksum error/RAM on a cold start.
I was sent a new TN790 but it has the wrong version
firmware. I have G3V6I.03.2.239.5 . The card they sent
has G3V6I.03.2.239.7 . Is there a way to copy my firmware
to the newer software card. If I try and boot with my Flash card with .5 on the .7 card it says I have a corupted
translations. I assume that the software must be different
as it works ok on the .5 card.

 

[wilsontec]

In theory , software can only upward use , so you .5 card can use in .7 processor card.

In you case , Please check the Ram must at least 16M , then startup the new processor card without plug-in flash card to check software version