TN2215 Analag Trunk

[vamosalavaya]

Dear All,

Is there a way to make an analog trunk based on TN2215 analog port ? I tried Co/fx/did with loopstart and i have message : 'object and port type inconsistent'

It work with MM714 on G700 but not with TN..

This need to be done in the aim to make an analog trunk between an G3si V7 and a G700 attached to an S87000.
I don't have free DS1 on G700 an I only need two or three lines
Regards,

Michael

 

[4merlucent]

You cannot do this on a TN2215, it is purely a station circuit pack

You could use a TN2147 CO Trunk which can support 8 analogue trunks and is relatively cheap.

 

[vamosalavaya]

Thanks you for this information.

I will wait for a free DS1 on G700...

 

[4merlucent]

do you have an analogue MM711 in the G700? those ports can be used as trunks or stations