Need help in configuring TN2198 BRI ports to Interface with VC and Dial-up. Using DataModule 64000, SPID 249001 and 249102. Call from Voice number and it hangs up after two rings. Status shows Activated but nothing else listed under TEI. Anyone know of a KB on how to configure. Avaya instructions Non-Existant. Will supply Detailed info to thread on reply.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Shaun E on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
TN2198 BRI Setup Help
- Thread starter saabnut
- Start date
Saabnut,
You can not call a BRI port from a voice port unless you have a BRI modem or device to convert. It must be bearer channel capable to talk. This card is for the NT single pair interface.
The calls are steered using BCC's at the trunk level. If you do not have BRI or PRI trunks in the system, you can not get out. You will only be able to dial BRI to BRI.
I spent two weeks getting video working. Avaya professional services will do the work if you need them to.
John
You can not call a BRI port from a voice port unless you have a BRI modem or device to convert. It must be bearer channel capable to talk. This card is for the NT single pair interface.
The calls are steered using BCC's at the trunk level. If you do not have BRI or PRI trunks in the system, you can not get out. You will only be able to dial BRI to BRI.
I spent two weeks getting video working. Avaya professional services will do the work if you need them to.
John
- Status
Similar threads
