TM3.1 CLID_ENTRY multiple changes

[ansellrk]

HELP!!!

I want to change 200 phones CLID entry on Key 0. All the phones are programmed with KEY 0 SCR XXXX with the CLID Entry set to 0, I want to change it to 2.

When I use TM31 (search or change) and select CLID_ENTRY=0 it finds no TN's, even though I know they are there!!! I can only assume, because there could be numerous CLID_Entries that there may be a syntax for doing this...

Is there another way?

Ta

 

[acewarlock]

It would be easier to change the programming on CLID 0 to the same as CLID 2 in the CDB.




This is a Signature and not part of the answer, it appears on every reply.

This is an Analogy so don't take it personally as some have.

Why change the engine if all you need is to change the spark plugs.

 

[ansellrk]

No... it wouldn't!

I have 0 set up as show real number
I have 1 set up as show nothing
I have 2 set up as show 576576
I have 3 set up as show 576033

etc, etc, etc.

I need to move 200 phones onto 0 without changing the other 1400 phones set to 2.

Unless I am misunderstanding what you are suggesting (which is possible!!)

 

[acewarlock]

Sorry




This is a Signature and not part of the answer, it appears on every reply.

This is an Analogy so don't take it personally as some have.

Why change the engine if all you need is to change the spark plugs.