Armstrong2012
Technical User
What is the normal acceptable time it takes to enter LSP mode?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Time it takes to enter LSP mode? 1
- Thread starter Armstrong2012
- Start date
- Status
montyzummer
IS-IT--Management
this is a setting you can change ,usually more than 3 mins
APSS (SME)
ACSS (SME)
APSS (SME)
ACSS (SME)
- Thread starter
- #3
montyzummer
IS-IT--Management
change system-parameters mg-recovery-rule 1 Page 1 of 1
SYSTEM PARAMETERS MEDIA GATEWAY AUTOMATIC RECOVERY RULE
Recovery Rule Number: 1
Rule Name: Migrate H.248 MG to primary: 0-active-calls
Minimum time of network stability: 3
WARNING: The MG shall only be migrated when there are no active calls.
APSS (SME)
ACSS (SME)
SYSTEM PARAMETERS MEDIA GATEWAY AUTOMATIC RECOVERY RULE
Recovery Rule Number: 1
Rule Name: Migrate H.248 MG to primary: 0-active-calls
Minimum time of network stability: 3
WARNING: The MG shall only be migrated when there are no active calls.
APSS (SME)
ACSS (SME)
-
1
- #5
montyzummer
IS-IT--Management
also you need to check the MGC list on your gateway to ensure it has a desination for the lsp (assumming you only have two servers) as the second entry in the MGC list
APSS (SME)
ACSS (SME)
APSS (SME)
ACSS (SME)
- Status
Similar threads
- Locked
- Question