the paging is busy

[port27]

Hi, anyone w/experince in opt 11c,when user use paging sounds busy,I will apreciate any advice.thanks

 

[GHTROUT]

The port is hung or in lockout.

Disable then Re-enable the Paging TN. The on the Route, set the TIMR TFD to 30

[©] GHTROUT.com [⇔] A Variety of Free Resources for Nortel Meridian/CS1000 System Administrators

 

[johnpoole]

ld 20
ltm
0
return.. that will give you the tn of the paging port.. then ld 32 disu x x.. enlu x x.. that fixes the problem.. then if you want to keep it from happening again.. out the pag trunk, out the rdb.. then add them back with trunk type wat or cot.. that gives you a timer, tfd.. timed force disconnect.. we use 180 sec.. if the calling party does not hang up in 3 minutes.. the call disconnects

it's a known problem with any loop start trunk.. usually when an analog station uses an analog trunk

john poole
bellsouth business
columbia,sc

 

[port27]

Hi.I disable the tn's paging and pull out crossconnet wires,then I enable the tn and punch down the wires and it works.thanks PS:ghtrout and johnpoole you rock.........!