Test lab ....Spid problem

[jamin123]

I run this config on 2 Cisco routers and a Marge ISND emulator, but it says "spid1 NOT valid". What spid I need?


R1
isdn switch-type basic-ni1
isdn spid1 0835866101 8358661
encaps ppp
ppp multi
!
dialer-list 1 protocol ip permit
!
int bri 0
ip address 10.1.1.1 255.255.255.0
dialer map ip 10.1.1.2 broadcast 8358661
dialer load-threshold 25 either
dialer-group 1
R2
isdn switch-type basic-ni1
isdn spid2 0835866301 8358662
encaps ppp
ppp multi

conf t
dialer-list 1 protocol ip permit
int bri 0
ip address 10.1.1.2 255.255.255.0
dialer map ip 10.1.1.1 broadcast 8358662
dialer load-threshold 25 either
dialer-group 1
end

R1#sh isdn stat
Global ISDN Switchtype = basic-ni
ISDN BRI0 interface
dsl 0, interface ISDN Switchtype = basic-ni
Layer 1 Status:
ACTIVE
Layer 2 Status:
TEI = 120, Ces = 1, SAPI = 0, State = MULTIPLE_FRAME_ESTABLISHED
TEI 120, ces = 1, state = 8(established)
spid1 configured, spid1 NOT sent, spid1 NOT valid
Layer 3 Status:
0 Active Layer 3 Call(s)
Active dsl 0 CCBs = 0
The Free Channel Mask: 0x80000003
Number of L2 Discards = 0, L2 Session ID = 10
Total Allocated ISDN CCBs = 0

 

[jeter]

your spids and dn are different is this a mistake on your part?

Normal Spids
70255512120100 5551212
70255512130100 5551213

“Reserve your right to think, for even to think wrongly is better than not to think at all”

Fisher CCNA, Network+