Nadeem khattak paki
Programmer
facing problem on Co to Co call transfer is still the LEDs blinking after drop the call from dual sides. and the dual line is in busy condition till enter in call manually dropped them. have any solution?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
TES-824 Conference problem
- Thread starter Nadeem khattak paki
- Start date
- Status
obtsystems
Programmer
You need cpc signal or reverse polarity on the lines to let the system know the call is finished
- Thread starter
- #3
Nadeem khattak paki
Programmer
Thanks for reply
In Tes 824 program code is 420-421 for cpc signal and 423 For REV signal what is correct value for these codes.
In Tes 824 program code is 420-421 for cpc signal and 423 For REV signal what is correct value for these codes.
obtsystems
Programmer
It will depend on if the line supports/ uses either of those. A lot of lines do have it, you would have to check with your provider
- Status
Similar threads