Hope this is right. What I need to do is terminate the "A" cabinet by takingoff the TDM cable that joins the ohter cabs. Somehow I think taking a terminator off the "C" to replace the TMD cable isn't the right way. I have PKT_BUS errors and am trying to make sure it's coming from the "A" cabinet. What set of pins should I put the terminator?? Where the TDM cable went or another set??
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Termination Check
- Thread starter EA6BMECH
- Start date
mikeydidit
IS-IT--Management
It sounds like you are trying to to B and C carrier off. If this is the case move the TDM bus terminator to the same location you removed cable that is going to the B carrier from A. Do not do this while the cabinet is up. Make sure you have the terminator is on the right pins before powering backup.
Mike Jones
LSUHSC
Mike Jones
LSUHSC
- Thread starter
- #3
mikeydidit
IS-IT--Management
The above link should help. Check out figure 7-18, it shows the TDM bus cable locations. On the backplane of the carrier it is marked TDM/LAN on the right slot.
Hope this helps.
Mike Jones
LSUHSC
- Status
Similar threads