I have 2 tenant groups, one is Tenant 2 route 3 and the other is tenant 4 route 6. They are not able to call each other or transfer calls using only the phone extention but can call other phones not in a tenant group using only the extension. I need to know how to set up tenant to tenant access. I know I need to make a change in ld 93, but I am kind of a newb to all of this and any help would be appreciated.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations wOOdy-Soft on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Tejant to tenant calling 1
- Thread starter laruecl
- Start date
-
1
- #3
LD 93 RACC (Tenant to Route Access data block)
It’s been a while but the tenant will be denied from access to the routs, you will need to build an Allow table and give access to each Tenant group to each route you add, or each route that you need to give each tenant access to.
It’s been a while but the tenant will be denied from access to the routs, you will need to build an Allow table and give access to each Tenant group to each route you add, or each route that you need to give each tenant access to.
- Thread starter
- #5
- Status
Similar threads
