Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

TCP Dynamic Ports for AD

Status
Not open for further replies.

acl03

MIS
Jun 13, 2005
1,077
0
0
US
We have a 2008R2 AD. I am trying to configure it through the firewall. We had a 2003 AD working fine through the firewall. The differences I am reading about for 2008 are the Dynamic High ports.

I know of the NETSH commands to limit the scope of ports it can use so we don't have to open tons of ports. The minimum is 1000 ports. Is there any good reason not to use that minimum number?

The old domain was configured to use 5000-5100. Any reason not to just configure the new domain to use 5000-6000, open those ports in the firewall and call it a day?

Thanks.

Thanks,
Andrew

[smarty] Hard work often pays off over time, but procrastination pays off right now!
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top