When configuring linecoding and so fourth on my Serial interface, I can choose either t1 or T1. Whats the difference? Also, instead of putting linecode commands on on the serial interface, I see it put on the "controller t1" in examples online, is this better practice, or whats the difference?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
T1 vs. t1, S0 vs. Controller t1???
- Thread starter necom
- Start date
Similar threads
- Locked
- Question