Systems Tied together with T-1 E&M- Issues on 7.1?

[Serenitynow109]

Good Afternoon,

Had a small issue with three systems we have tied together with E&M T-1. Prior to the upgrade all three systems had 6.0 Software. The third system was upgraded recently to 7.1XC due to the need for the 13th and 14th ports on the Combo Card.Since the upgrade, the system upgraded to 7.1 cannot communicate or be communicated with. Programming was reproduced exactly.

Anyone out there have any issues similar to what we are experiencing?

Thanks in advance.

 

[RikRodgers]

I haven't had any trouble upgrading, but I know others have run into database corruption when upgrading system software. You could try changing the settings, exit programming, then go back in and change them back.

The only sure fix (IF it's a corrupted database) is to run startup and reprogram.

 

[gforce9]

I remember going from MICS 2.0 to 4.0 and having DID cards stop working. The fix?....disable cards in 'Maintenance', go to 'Hardware' and s/w change card type, power down & swap cards to LS/DS (that's all I had), re-enable in 'Maintenance', disable in 'Maint', go to 'Hardware', chage card type back, power down & put cards back, re-enable in 'Maint', voila! Actually swapping the cards out may not be necessary, but I only did it once, so I didn't get to play with it.