SX200 AX ICP>Changed DHCP Scope

[jabbo99]

Hey, I'm fooling around with my 200 in my lab. I changed the IP address, D/G and DHCP scope then rebooted my system. The system comes up and I'm able to access it. I plugged my console in, it pulls an IP address from the new scope(10.1.1.20). Howver, the ICP IP address populating on the console's display is incorrect. It remains to be the default IP address: 192.168.1.2

I searched my systems settings and confirmed all IP changes were correct. However, I fear I've missed something...

For giggles, I manually assigned the console a static IP address, S/M, D/G, and ICP IP address. It comes up just fine and functions properly. What have I overlooked?

Thanks

 

[jabbo99]

Any assistance is appreciated.

Thanks

 

[sarond]

I'm not familiar with SX200, but if anything like 3300 you also have to make sure Option 125 is set correctly. (Or any other relevant options for that matter)
You can't just change the DHCP scope addresses.

 

[jabbo99]

DHCP Common Options

3-Router is set to 10.1.1.1
125-Mitel is set to ASCII 1027
128-IP phone TFTP Server is set to 10.1.1.2
129-ICP IP Addreess is set to 10.1.1.2
130-DHCP Server identifier is set to ASCII Mitel IP Phone
134-DiffServ Code Point is Numeric 46

 

[sarond]

There should be a value of the 125 ASCII String, this would have all the encapsulated option in it normally.
i.e. ICP, TFTP, VLAN, DSCP... all in one option.