Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Wanet Telecoms Ltd on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

sx 200 LW19 T1 to PRI

Status
Not open for further replies.

rcc1000

Vendor
Aug 26, 2013
249
US
I have a SX 200 LW19 that they want to swap a T1 for a PRI
 
They'll need the card with module and a network link license.
 
As jpruder suggests PRI runs on a completely different card than the T1

The Module may not be required though as the PRI card can run without one in either slot 10 or 11 in the main control cabinet.

A network link license is required but I can't remember if one would be required for the T1 so that may just be a wash.

**********************************************
What's most important is that you realise ... There is no spoon.
 
in form 4 option 96 if it says you have 1 or more links you are good. You will need a Pri card 9109-615-001-NA and the T1/E1 module 9180-510-004-NA, if the Pri card in installed in bay 1 you do not need a fim or cim card.
If you install the card in the control cabinet, bay 1, make sure you set the dip switches on the Pri card to 1 closed and 2 open, if not the card will not work. If you install the card in a per bay then the dip switches are 1 and 2 closed.
I try and install in the control cabinet, slot 10 is bay 2 and slot 11 is bay 4 then.
 
Ah, PRI module not CIM/FIM Module.

My bad, I thought the module jpruder referred to was for peripheral control. I forgot the PRI card has the T1 card as a daughter board.

If your Slot 10/11 in Bay 1 are in use then you will need a FIM/CIM module to run the PRI card in a Per Bay.

**********************************************
What's most important is that you realise ... There is no spoon.
 
The network link license is only required for the PRI card or T1 module on BCCIII card. Another thing to remember is to make sure the number of links for the card is correct for MOH to function correctly if in the control cabinet.

Link license 54002469.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top