Switch Configuration

[sx0sx]

Hi...new to the commands and configuration of cisco switch n routers but have assessment on this. If possible anyone can help provide me the steps of command to configure as per diagram below

(1)2901------VSAT----2901 (10.23.251.133 255.255.255.0)
|
|
(2)2960(48port)
|
|
(3)WIMAX (Bridge)
|
|
(4)WIMAX (Bridge)
|
|
(5)2960 (24port)---(uplink port 24)---(6)2960(24port)


i need to configure

(1)2901
ip address:10.23.251.134 255.255.255.0


(2)2960(48)
vlan:10
ip address:10.20.96.1-10.20.96.253
Gateway: 10.20.96.254
Subnet: 255.255.255.0

vlan:20
ip address:10.20.97.1-10.20.97.253
Gateway: 10.20.97.254
Subnet: 255.255.255.0

(3)wimax
ip address:

(4)wimax
ip address:

(5)2960 (24port)
vlan:30
ip address:10.20.98.1-10.20.98.253
Gateway: 10.20.98.254
Subnet: 255.255.255.0

vlan:40
ip address:10.20.99.1-10.20.99.253
Gateway: 10.20.99.254
Subnet: 255.255.255.0


(6)2960(24port)
vlan:30
ip address:ip address:10.20.98.1-10.20.98.253

vlan:40
ip address:10.20.99.1-10.20.99.253

 

[sx0sx]

any one can help me....