Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

STOP PARTITION

Status
Not open for further replies.
GEORGEJD

GEORGEJD

Programmer
Joined
Jun 8, 2007
Messages
1
Location
PE
Hi everybody:

I used the following DB2 command:

-STOP DATABASE(DSN8D71A) SPACENAM(XEMP2) PART(1)

And after then, I could not give the load utility, but I can give SELECT to rows that are on the Partition 1 and I saw the rows in Partion 1.

Is there some way that I could not see the rows on Partion 1 ??

Regards

George
 
Status
Not open for further replies.

Similar threads

Prince26
  • Locked
  • Question Question
Table Partitioning in db2
Replies
0
Views
209
Prince26
Prince26
SantaMufasa
  • Locked
  • Question Question
Cannot stop or start the DB2 instance
Replies
2
Views
223
SantaMufasa
SantaMufasa
RonvdP
  • Locked
  • Question Question
Cleaning a partitioned table
Replies
2
Views
222
Truusvlugindewind
Truusvlugindewind
DavidMedici
  • Locked
  • Question Question
Updating Partition Key columns
Replies
0
Views
113
DavidMedici
DavidMedici
krishrad
  • Locked
  • Question Question
load into a single partiton on a multi partitioned table
Replies
0
Views
151
krishrad
krishrad

Part and Inventory Search

Sponsor

Back
Top