Steering codes

[leatherneckdiver]

I have a CS1000M that is connected to a Siemens gateway with a PRI connection. I am having a problem with CDR of the digits dialed across this route. Example, one of the steering codes is 2009, where the digits dialed are 200-9174 to reach the remote site. The route ACOD is 8007. When I look at the CDR output it shows 8007174 for the digits dialed. Is there a way to get all digits dialed to be output in the CDR? Which would be 80072009174.

 

[DFKSydney]

Couple of things:

1: Is your flen for the code long enough? Its possible that you are accessing the link then using inband signalling after that (remote possibility).

2: LD 15 CDR. 2 parameters in there... CDPR and ECDR.

Beware of ECDR though. This will cature ALL digits dialled. The issue here is that in capturing everything is that nothing is sacred..... eg: your telephone banking etc. This leads to one massive privacy and security issue.