Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

startalk question ?

Status
Not open for further replies.

macphoneguy

IS-IT--Management
Feb 21, 2002
485
US
I relaize this depend on particular but let say I have a 0x32 & a startalk flash unit, if initialized call come in and goes to voicemail, the message plays, and the caller leaves a message, is it then possible to call out to a predefined beeper, and spit out a code like "44444" that would appear on the beeper, if so what would the required flash Version ?

thanks in advance
 
You need to set up a outdial within the mbox, you will see you have a option for phone or pager. Put the number in along with some pulses ie. 410.xxx.xxxx ppp 4444pp # This should work for you.

Jeremy J. Carter
Charm City Communications
Norstar. BCM. CS1000 Programmer
 
Don't use passwords like 1234.

As for what is says on the pager display if you select Pager it should display the mailbox #, if you want any thing other then that then select Phone and do as Norstarboy states.
P = Pause (1.5 seconds)
Depending how long it takes for the pager to answer and be done with its greeting depends how many pauses required.


=----(((((((((()----=
curlycord
 
Toll Fraud is not a concern.
The VM is calling a specific number, sending digits, then disconnecting the call.

Flash doesn't have the ability to do Outbound Transfer which is what they typically use for Toll Fraud.

-SD-
 
If the pager is a local call. and that is the only number you need to out call to . put a toll restriction on your locals associated with the flash, or call pilot if anyone hacks your voicemail it will be restricted to local calling only.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top