Stange issue SCN

[VoiceonData]

I moved an IP OFFICE (IP 500) at the weekend - 3ft from one cab to another.

It was connected to 4 sites using SCN and all was working

now 3 out of the 4 work 1 doesnt ???

All cables have been re connected, you can ping in both directions usings System Status.

End B is showing SCN as being UP

END A is showing the SCN as Not ENABLED

the monitor application is showing the SCN as down and the tx and rx are showing as 0

Any Ideas ??????

voiceondata

http://www.voiceondata.co.uk

 

[tlpeter]

Try rebooting both

ACS - Implement IP Office
ACA - Implement IP Telephony -- ACA - Design IP Telephony
ACA - Voice Services Management
______________
Women and cats can do as they please and men and dogs should relax and get used to the idea!

 

[VoiceonData]

rebooted both ip offices

and both vpn routers still not working

voiceondata

http://www.voiceondata.co.uk

 

[tlpeter]

Remove the iplines in both reboot and make them again and reboot

ACS - Implement IP Office
ACA - Implement IP Telephony -- ACA - Design IP Telephony
ACA - Voice Services Management
______________
Women and cats can do as they please and men and dogs should relax and get used to the idea!

 

[VoiceonData]

it seems to have been and issue with line group id

they were differnt at each end

eg

A END was 101
B END was 105

strange thing is it worked before the move

anyway all working now

thank you tlpeter for the response

voiceondata

http://www.voiceondata.co.uk

 

[photon33]

I thought different IP LG id's on each switch was recommended for anti-tromboning...







------------------------------------------
Wash, rinse, repeat.

 

[amriddle01]

You are supposed to make them different so you can use other systems trunks and to ensure correct function of SCN!!

ACS - IP Office Implement

"I'm just off to Hartlepool to buy some exploding trousers