TheHead1
Technical User
- Aug 29, 2011
- 6
I'm very new to Cisco ASAs and their setup/configuration.
I've setup a basic SSLVPN with both web mode and tunnel mode to demo this for a client we support. It's setup on an ASA in one of their locations.
This ASA5505 has fully-meshed IPSec VPN to their other sites.
Each site has their own IP range configured.
I've successfully got the SSLVPN setup and allowing access to the network where the ASA is setup.
Is there an easy way to set this up to allow the traffic when connected via SSLVPN to allow access to the networks that are accessible over the IPSEC VPN tunnels?
I've tried a few things, like adding networks to allow tunnelling to, etc, but can't seem to make this work.
They are using version 8.2 of the ASA software.
Thanks,
TheHead1
I've setup a basic SSLVPN with both web mode and tunnel mode to demo this for a client we support. It's setup on an ASA in one of their locations.
This ASA5505 has fully-meshed IPSec VPN to their other sites.
Each site has their own IP range configured.
I've successfully got the SSLVPN setup and allowing access to the network where the ASA is setup.
Is there an easy way to set this up to allow the traffic when connected via SSLVPN to allow access to the networks that are accessible over the IPSEC VPN tunnels?
I've tried a few things, like adding networks to allow tunnelling to, etc, but can't seem to make this work.
They are using version 8.2 of the ASA software.
Thanks,
TheHead1