Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Spectralink SVP100 Factory Reset
- Thread starter narsman
- Start date
To login into the SVP server, if your password is forgotten;
a. Connect your terminal to the RS-232 port using a null-modem cable. Open a terminal emulation program, such as HyperTerminal TM, in order to communicate with the gateway.
b. Power cycle the SVP server.
c. When the login: prompt appears, within 60 seconds, enter the login maint, and press Enter.
d. The slnk > prompt should appear.
e. Type password admin and press Enter.
f. The system should inform you that your password has been changed back to admin.
g. When the slnk > prompt reappears, type exit, and press Enter.
h. You should now be able to login as normal.
a. Connect your terminal to the RS-232 port using a null-modem cable. Open a terminal emulation program, such as HyperTerminal TM, in order to communicate with the gateway.
b. Power cycle the SVP server.
c. When the login: prompt appears, within 60 seconds, enter the login maint, and press Enter.
d. The slnk > prompt should appear.
e. Type password admin and press Enter.
f. The system should inform you that your password has been changed back to admin.
g. When the slnk > prompt reappears, type exit, and press Enter.
h. You should now be able to login as normal.
- Thread starter
- #3
- Status
Similar threads
