SOLVED! Digital tie trks to non-Nortel PBX's

[Jumpermonkey]

The solution to get the tie trks able to dial into the far end(s) was in the Nortel Trunk Route. In LD16, there is a param DSEL which defaults to VOD (Voice Or Data). This had to be changed to VCE (Voice Only) to allow dialing in to each switch. All is well and thanks again, John!

Jumpermonkey

 

[johnpoole]

voice over data will cause lots of problems, had one co "277" that could not send did calls over a tie for the same reason, worked perfect tothe 81 but wouldn't follow the tsc to remote switch across a tie, everything else worked. hard to believe we get paid for this

john poole
bellsouth business
columbia,sc

 

[ArchibaldJCox]

Sorry I didn't look at your original post. Nortel recommends that any digital TIE trunks that DON'T use a D-Channel ALWAYS be programmed as VCE or 3VCE as VOD almost always cause problems.

Arch

------

http://www.infoplusonline.com

Site Surveys
SourceBooks
Security Audits
Traffic Studies
Remote PBX Backups

 

[Jumpermonkey]

My thanks to all!
This forum is priceless!
JumperMonkey

 

[MacMan11]

Priceless is only half of its worth thanks to the wonderful folks that listen in. To john and others if you're ever in Niagara Falls let me know as the drinks are on me.