I'm trying to setup and see what the Inventory Collector shows in SMGR. I have my CM setup as a managed element and have sync'd the DB successfully. I'm having issues with the inventory collection piece. I enabled SNMP on the CM web interface and setup the same credentials on the SNMP section. I added in the username to access CM.. the MG credentials and the subnet for all these elements. I ensured SNMP V3 was flagged in the proper places (at least I think), but what is happening is:
CM was recognized, but the MG and SYS Plat didn't get noticed
CM then disappeared and I was able to get it captured one more time out of 5 attempts
I see the system is probing an IP in the subnet that is not used, nor does it seem to be searching the entire range and is focusing on only 1 IP and then goes idle.
Anyone have any tips for how this should be working?
CM was recognized, but the MG and SYS Plat didn't get noticed
CM then disappeared and I was able to get it captured one more time out of 5 attempts
I see the system is probing an IP in the subnet that is not used, nor does it seem to be searching the entire range and is focusing on only 1 IP and then goes idle.
Anyone have any tips for how this should be working?