AUAB
Technical User
- Sep 11, 2012
- 3
I have a Nortel Passport 2430 and need to configure a route. What are the commands needed to create a route where the destination IP? What site manager do you recommend I download?
Thanks,
Thanks,
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Site Manager?
- Thread starter AUAB
- Start date
- Status
Configuration is much easier with site manager rather than using the command line. To figure out the version you need check the release notes for the software you are using on the 2430.
If you still have the software cd it will have the correct site manager version.
If you want to configure a static route from the command line you need to enter the bcc and from the global prompt enter
static-route address <destination> mask <ip_mask> next-hop-address <next_hop>
If you still have the software cd it will have the correct site manager version.
If you want to configure a static route from the command line you need to enter the bcc and from the global prompt enter
static-route address <destination> mask <ip_mask> next-hop-address <next_hop>
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question