Site Code and Cli across DPNSS network

[jackdaniels1955]

I`m trying to get full CLI to go across the DPNSS network, i.e own site code and extension number. I have set EXNOPR to be equal to the site code but then only this gets delivered and not the extension number, if I remove it I only get the extension number. Any ideas??? I need it for call back(ring again) to work properly.

 

[ysgoh88]

what the parameter you using for route and extension?

 

[jackdaniels1955]

Route data below,

Thanks,

JD.

<RODDPEST=327;
EXTERNAL DESTINATION DATA
DEST DRN ROU CHO CUST ADC TRC SRT NUMACK PRE
327 70 15000000000250 0 1 0

END

<ROCAP:ROU=70;
ROUTE CATEGORY DATA
ROU SEL TRM SERV NODG DIST DISL TRAF SIG BCAP
70 012000000000 5 0110000000 0 30 128 03151515 111110000011 1111

END

<RODAP:ROU=70;
ROUTE DATA
ROU TYPE VARC VARI VARO FILTER
70 TL50 H'00000401 H'00000000 H'00000000 NO

END

<RONDP:ROU=70;
ROUTE NUMBER DATA
ROU PRE ROUDIR TLID EXNOPR TERAC
70 5-323

END

<KSDDPIR=3001;
KEY SYSTEM DIRECTORY DATA
DIR CUST EQU CAT ADN ODN CALALT
3001 001-1-42-04 4 1

END

<EXCAP:CAT=4;
NOT ACCEPTED
DIR
MISSING
<KSCAPIR=3001;
KEY SYSTEM CATEGORY PRINT
DIR TRAF SERV CDIV ROC ITYPE TRM ADC AGENT
3001 03151515 00021206 001151222 0000 20 1 0000000001 0

END

<EXCCP:CAT=4;
EXTENSION CATEGORY CODE
CAT TRAF SERV CDIV ROC
4 03151515 00021206 001151222 0000

END

 

[Isinor]

In pre BC11 systems you could use TON (type of number) unknown as you have EXNOPR=5-xxx in BC11 you must use EXNOPR=6-xxx and set the RODDIEST=xxx,ACD=x6x61xxxxxx to match.

 

[mdfan]

I may confirm that what Isinor says is correct , we run this for our VPN network.
Only thing is that we have ADC=x5x61xxxxxx.
And works OK.
We run ISDN towards IN node though.

 

[whosrdaddy]

the x6x61 adc parm is not usefull for his problem since we're talking BC7 here (14 digit ADC parameter). I'm not even sure if this works properly in BC7

to jackdaniels : maybe it's time to think about a SW upgrade of your PBX...

greetings,

http://www.damovo.com