Show version output from 2621XM

[EYES]

SUBNETRTR>sh ver
Cisco Internetwork Operating System Software
IOS (tm) C2600 Software (C2600-I-M), Version 12.2(8)T5, RELEASE SOFTWARE (fc1)
TAC Support:

http://www.cisco.com/tac

Copyright (c) 1986-2002 by cisco Systems, Inc.
Compiled Fri 21-Jun-02 08:50 by ccai
Image text-base: 0x80008074, data-base: 0x80A2BD40

ROM: System Bootstrap, Version 12.2(7r) [cmong 7r], RELEASE SOFTWARE (fc1)

SUBNETRTR uptime is 2 minutes
System returned to ROM by power-on
System image file is "flash:c2600-i-mz.122-8.T5.bin"

cisco 2621XM (MPC860P) processor (revision 0x100) with 27648K/5120K bytes of memory.
Processor board ID JAD06510N1Q (1465415040)
M860 processor: part number 5, mask 2
Bridging software.
X.25 software, Version 3.0.0.
2 FastEthernet/IEEE 802.3 interface(s)
1 Serial network interface(s)
32K bytes of non-volatile configuration memory.
16384K bytes of processor board System flash (Read/Write)

Configuration register is 0x2102

 

[mainstreetexpress]

Yup, you have IP based IOS which doesn't support IPX routing. That's why you can't see the commands

You will have to upgrade to IP/IPX/APPLETALK based IOS

Cheers

Mark

 

[EYES]

Thankyou, for shining the light I had my suspicions. How did you know what was supported by this IOS?

 

[EYES]

Mark,

Never mind after drilling through Cisco's site I finally found a list of features for the bin file. Guess I'll have to get a smartnet account setup.

Thanks again,

John