Show controllers t1

[2keys]

I have been reading up quite a bit on T1 troubleshooting. This is the first time that I have played with a T1 so pardon the question

Whenever I do sho controllers t1 nothing displays.

Per Cisco

http://www.cisco.com/en/US/tech/tk7...ech_note09186a0080104552.shtml#showcontroller

This is supposed to help quite a bit in trying to pin point the problem. What am I doing wrong?

If I do show controllers on the csu/dsu I get very little in terms of usefull information.

 

[2keys]

I just realized why we can not. This command is apparently only available on certain wics if the configuration is set properly.

Sort of a bummer because that was a good guide to troubleshoot.

 

[burtsbees]

Do you have the controller configured at all? If there is nothing configured, there is nothing to show.

Burt