Short Codes for SIP 1

[jamie77]

Our ITSP will only accept calls in the INVITE if all digits are sent at once.

The only way I can get this is to have the following short code:

7XXXXXXXXXXX
N"@10.10.10.10"
Dial
15

This causes a problem with local calls without STD code.

Is there a way to force the SIP trunk to wait until all digits are dialled before sending the INVITE to the ITSP??? like ETSI en-bloc??

This is in the UK BTW.

Jamie Green

IPO ACA:Implement

http://www.alliedcom.co.uk

Fooball is not a matter of life and death-It is far more important!!!!

 

[intrigrant]

In system>telephony :
Dial Delay Timer = 4
Dial Delay Count = blank or zero

All function codes of the type "Dial" must end with ;

The shortcode to your SIP line will be like :
7N;
N"@10.10.10.10"
Dial
15

Alternatively you can send the SIP call to a ARS page and do the following:
System shortcode =
7N
N"@SIP URL"
DIAL
51:SIP ( this is the ARS page to create )

On the ARS page you can select to use the system dial delay timer or set a specific value, set it to 4.
Create a shortcode like this :
N;
N"@SIP URL"
Dial
15

 

[jamie77]

I tried the dial delay count. All it did was make the system take longer to dial internal extn no's. It didn't help the external calls.

I think I will have to have short codes like:

0XXXXXXXXXX
2XXXXXX
3XXXXXX.... etc

Jamie Green

IPO ACA:Implement

http://www.alliedcom.co.uk

Fooball is not a matter of life and death-It is far more important!!!!

 

[jamie77]

Sorry, That will teach me to read posts properly.

Just noticed the ;.

I will give that a go.

Thanks Fella

Jamie Green

IPO ACA:Implement

http://www.alliedcom.co.uk

Fooball is not a matter of life and death-It is far more important!!!!

 

[PlatinumGuy]

Part of the RFC for SIP is that the whole number must be present in the invite, you cannot use overlap dialing on SIP.

 

[jamie77]

Good man Intrigrant.

Got it to work.

All I have to do now is sort out dialling using the 1 SIP trunk we have 1st then backup to our PRI.

Should be easy!!!!!!!!!!!

Jamie Green

IPO ACA:Implement, ACS: IP Office

http://www.alliedcom.co.uk

Fooball is not a matter of life and death-It is far more important!!!!

 

[ducatisenna]

hi
i make this conf , and it is working, but it says unobtainable , and calls cant success, is there a way to achieve this
avaya ip office small office edition 4.0.(5) local argentina

i write only system shortcode

8N; dial N"@ipaddress" 9

please help me

thanks
serhan from cablenet

 

[intrigrant]

If it says onobtainable then there is either a license problem or authentication problem.

 

[ducatisenna]

i think the problem is that

191784873mS SipDebugInfo: License, Valid 1, Available 1, Consumed 1
191784874mS SipDebugInfo: Outgoing Call in excess of License: Consumed: 1, Available: 1


what is the solution about this error message.

i have sip trunk channels instance 1 licence,

i can dial somewhere and later i can not dial, i wait for a minute, state changes , and i can dial again,

i dont understand, isp did not give me a password,
and i ticked the registration required button,

is problem about license or authentication.how can i solve this.

thanks.






191784867mS CMTARGET: 0.1916.0 285 ILKNUR YUMUK.0: TimerExpired cause=1
191784868mS CMTARGET: 0.1916.0 285 ILKNUR YUMUK.0: LOOKUP CALL ROUTE: type=100 called_party=800441904544545 sub= calling=121 in=0 complete=1
191784868mS CMTARGET: SKIP INCOMING CALL ROUTE
191784869mS CMTARGET: 0.1916.0 285 ILKNUR YUMUK.0: ADD TARGET (N): number=800441904544545 type=100 depth=1 nobar=1 setorig=1
191784869mS CMTARGET: 0.1916.0 285 ILKNUR YUMUK.0: FoundKnownSystemTargets 800441904544545
191784871mS CMTARGET: 0.1916.0 285 ILKNUR YUMUK.0: SYS SC: 800441904544545 3 00441904544545 sc=type=31 code=8N;, num=N"@212.252.48.5" callinfop->sending_complete=1 secondary_dialtone=
191784872mS SipDebugInfo: SIPTrunks: Make Target voip, line group id is 9 and ip of d4fc3005
191784873mS SipDebugInfo: License, Valid 1, Available 1, Consumed 1
191784874mS SipDebugInfo: Outgoing Call in excess of License: Consumed: 1, Available: 1
191784875mS CMTARGET: DIAL LINE: 285 GROUP = 9 SUCCESS = 00000000
191784878mS CD: CALL: 0.1916.0 State=0 Cut=0 Music=0.0 Aend="ILKNUR YUMUK(121)" (1.3) Bend="" [] (0.0) CalledNum=800441904544545 () CallingNum=121 (ILKNUR YUMUK) Internal=1 Time=2036 AState=7
191784879mS CD: CALL: 0.1916.0 Deleted
191784879mS CMCallEvt: 0.1916.0 -1 ILKNUR YUMUK.0: StateChange: END=X CMCSDialling->CMCSCompletedTone
191784882mS CMCallEvt: 0.1917.0 -1 BaseEP: DELETE CMEndpoint ffcb5088 TOTAL NOW=2 CALL_LIST=0
191784883mS CMCallEvt: END CALL:285
191785023mS CD: CALLSYNC: cs02

191785178mS SipDebugInfo: Timer 11 callback
191785179mS SipDebugInfo: Completed ... removing Dialog of CallId: 2ee49af6391133bfa47dd65cbab7d18d@10.0.0.250 and State: 40
191785180mS SipDebugInfo: Registration Expiry mRegPendings are 0, and 0, dTimer 11, state 40
191785180mS SipDebugInfo: SIPDialog destructor ... ffd41348
191785180mS SipDebugInfo: SIPDialog - Free SDPBody....
191785185mS CMCallEvt: 0.1915.0 -1 SIPTrunk Endpoint: StateChange: END=X CMCSConnected->CMCSDelete
191785185mS SipDebugInfo: ~SipTrunkEndpoint
191785194mS CMCallEvt: 0.1915.0 -1 BaseEP: DELETE CMEndpoint ffcb9398 TOTAL NOW=1 CALL_LIST=0
191785195mS SipDebugInfo: Dialog has been deleted
191814881mS CMCallEvt: 0.1916.0 -1 ILKNUR YUMUK.0: TimerExpired State=CMCSCompletedTone
191814882mS CMCallEvt: 0.1916.0 -1 ILKNUR YUMUK.0: StateChange: END=X CMCSCompletedTone->CMCSCompleted
191814885mS CMCallEvt: 0.1916.0 -1 ILKNUR YUMUK.-1: StateChange: END=X CMCSCompleted->CMCSDelete
191814886mS CMTARGET: 0.1916.0 -1 BaseEP: ~CMTargetHandler
191814887mS CMCallEvt: 0.1916.0 -1 BaseEP: DELETE CMEndpoint ffcb1384 TOTAL NOW=0 CALL_LIST=0