Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Set up CLI
- Thread starter techpc
- Start date
Pls be more specific. Are you speaking about MD110, BP, or maybe Avaya/Mitel/Alcatel? Route type? PRI? Some kind of data would also be nice to see (NA, RO, EX/KS etc.). With this kind of question without any information you'll never get an answer....
- Thread starter
- #3
If you have 10 PRI`s and you want to show always the same CLI, you can try to use Number Conversion (NUTRI)
ask your provider if "clip no screening" is allowed on this PRI`s.
Allow number conversion on the outgoing route(s) (SERV-Parameter)
ENTRY 1 (for all extensions starting with 1 (1000 to 1999)
CNVTYP 1 (sent A number)
NUMTYP 10 (internal dir. Nr. sent to public)
PRE .. (the CLI you want to sent in front of your DDI-number)
NEWTYP 1 or 2 (international or national ??? ask your provider, which type of number will be accepted)
ROU (route number, where this CLI should be shown)
This is one way, how to do. (also possible with RONDI and EXNOPU-parameter)
best regards,
Norbert
ask your provider if "clip no screening" is allowed on this PRI`s.
Allow number conversion on the outgoing route(s) (SERV-Parameter)
ENTRY 1 (for all extensions starting with 1 (1000 to 1999)
CNVTYP 1 (sent A number)
NUMTYP 10 (internal dir. Nr. sent to public)
PRE .. (the CLI you want to sent in front of your DDI-number)
NEWTYP 1 or 2 (international or national ??? ask your provider, which type of number will be accepted)
ROU (route number, where this CLI should be shown)
This is one way, how to do. (also possible with RONDI and EXNOPU-parameter)
best regards,
Norbert
- Status
Similar threads
