Hi Again,
I was wondering how to set a default baudrate. It would be great to set it using automation but when I try "set port baudrate BRATE" where BRATE is anything other than 115200, I get an error message at the bottom of ProComm saying "Unable to set communication state". I tried this with automation as well as manually by changing the baudrate by clicking on the baudrate box at the bottom of the terminal and changing it. I also tried changing it in the Options -> Modem Connection -> Modem/Connection Properties Menu and still the same result. The device that's connected to the port is set at 57600 and can be set to any of the ProComm supported baudrates. I changed the device's baudrate in a hyperterminal but in order to communicate with it in ProComm, ProComm needs to be operating at the same baudrate. Any help and an example would be greatly appreciated. Thanks.
I was wondering how to set a default baudrate. It would be great to set it using automation but when I try "set port baudrate BRATE" where BRATE is anything other than 115200, I get an error message at the bottom of ProComm saying "Unable to set communication state". I tried this with automation as well as manually by changing the baudrate by clicking on the baudrate box at the bottom of the terminal and changing it. I also tried changing it in the Options -> Modem Connection -> Modem/Connection Properties Menu and still the same result. The device that's connected to the port is set at 57600 and can be set to any of the ProComm supported baudrates. I changed the device's baudrate in a hyperterminal but in order to communicate with it in ProComm, ProComm needs to be operating at the same baudrate. Any help and an example would be greatly appreciated. Thanks.