Server time change doesn't "take"

[mnealtx]

G3R upgraded to CM 2.2

Switch is standalone, no network (internet) connections. Synch sources are DS1 circuit packs. Being a G3, cannot time-sync to ASA computer.

Time stamp is 12 minutes slow. No offsets in time synch under the tools/maintenance tab.

If I set time in maintenance access website, server 'takes' the time. Check time on ASA, time is correct.

Five minutes later, time has reverted to 12 minutes slow. Any ideas why?

Any help is appreciated.

 

[mnealtx]

There's two servers, had to set time on both in the maintenance web access page.

Several hours later, still on-time.

 

[AvayaTier3]

Sounds like "ntp" is enabled and the one server is programmed to sync to the time of the other server.
Check your "ntp" settings and make sure the "ntp" resources are reachable.

A great teacher, does not provide answers, but methods to teach others "How and where to find the answers"

bsh

40 years Bell, AT&T, Lucent, Avaya
Tier 3 for 30 years and counting
[URL unfurl="true"]http://bshtele.com[/url]

 

[mnealtx]

Since setting time on both servers, it's displayed the correct time and not reverted back to 12 min slow as it was doing.

The switch is set up as a standalone - there's no internet connection for it to get NTP data from.

Is that something I can check through the maintenance access webpage?