Sending *ani*dnis

[chevyman440]

I have a tie line setup to another pbx (not Avaya). I am receiving *ANI*DNIS and that works fine INCOMING on my tie line. It is not, however, sending that information on an outgoing call. It simply sends the digits to dial. The feature I turned on on page two of the trunk group:

Incoming Tone (DTMF) ANI: *ANI*DNIS*

G3SiV6

Any way to enable it to send? It's expecting it on the far end... in fact I defined it as feature group D featd. And yes, this is a simple E&W type tie line...no pri possible because I have no processor channels left... bummer.

-Matt

 

[kva]

I'd faced with the same problem a few years ago. The only way I'd found is placing fixed *ANI* digits before dialed digits in route pattern.